Freeze dryer construction and component functions

Jun 01, 2020 Leave a message

The freeze dryer is composed of a drying oven, a refrigeration system vacuum system, a media heat exchange circulation system, an automatic control system, a pneumatic system, and an in-situ cleaning and disinfection system.

Freeze dryer drying oven

The drying oven is a vacuum-sealed low-pressure container, all materials are made of stainless steel, can withstand positive and negative pressure, and meet the requirements of steam sterilization. The sealing is made of high-temperature and low-temperature-resistant silicone rubber, and the insulation layer is made of closed-cell elastic thermal insulation materials.

1) Box: A rectangular box with a high space utilization rate is used. The bottom is provided with a drainage port, and an observation window is opened on the side. 、Spray inlet joint.

 2) Shelf: The energy required to cool and open the food is transmitted to the shelf through the heat exchange medium to the food. The shelf uses special hollow plywood, which has high strength and good sealing. The shelf assembly is installed in the freeze-drying cabinet through a bracket. The uppermost layer should be set as a heat radiation compensation board to ensure that the food space in the cabinet is under the same temperature environment. In addition, both sides and the back of the shelf are Set up rails to prevent food trays or food from coming off the shelf.

 3) Box door: adopt cylinder automatic locking device. Ensure: the vacuum required during the internal pressure of the cabinet. When the vacuum pump is working, the thousand boxes of butterfly rooms are opened. The air and water vapor in the vacuum drying room pass through the water trap to capture the moisture and enter the vacuum pump. The vacuum pump exhaust port is discharged from the system. The vacuum pump exhaust port is equipped with an oil mist trap. To prevent the smoke in the exhaust gas from polluting the indoor environment. In order to prevent water vapor from entering the pump, the system is equipped with a gas ballast valve, which is opened during the drying process.

Freeze dryer media heat exchange circulation system

The energy required to cool down and heat up the food is driven by the circulation pump and transferred to the shelf through the heat exchange medium to the food. The cold source of food cooling is provided by the refrigeration system, and the heat source of food heating is provided by the heating tank. The switching between cooling and heating is accomplished by controlling the electromagnetic valve switches of the cold source and the heat source. When the temperature rises, the steam enters the heating tank to heat the medium, and the pneumatic three-way regulating valve is used to adjust the mixing ratio of the heat medium from the heating tank and the shelf return heat medium, and the cooling water of the plate heat exchanger is used to open and close the valve to control the shelf. temperature. The system has heat medium heating tank plate heat exchanger, pneumatic regulating valve, cooling water solenoid valve, circulation pump, pipeline, solenoid valve, temperature sensor, etc.

Automatic control system of freeze dryer

It has functions such as freeze-drying curve setting, vacuum pump testing and control, media temperature, food temperature water trap temperature control, dry state detection, path removal, in-place cleaning and sterilization, automatic protection and alarm.

Pneumatic system of freeze dryer

Control pneumatic valve

Freeze dryer in-situ cleaning and disinfection system

Used for cleaning and steam sterilization of dry box traps

Freeze dryer in-situ cleaning and disinfection system

Used for cleaning and steam sterilization of dry box traps

1- (5)(001)

Send Inquiry

Send Inquiry