The main unit of the freeze dryer is mainly divided into a dry box and a water catching tank. What role does the front cabin of the freeze dryer, that is, the dry box play in the entire freeze dryer?
The drying oven is a vacuum-sealed low-pressure container, all materials are made of stainless steel, can withstand positive and negative pressure, and meet the requirements of steam sterilization. The sealing is made of high-temperature and low-temperature-resistant silicone rubber, and the insulation layer is made of closed-cell elastic thermal insulation materials.
1) Box: A rectangular box with a high space utilization rate is used. The bottom is provided with a drain port and an observation window is opened on the side. The box is also equipped with a pressure gauge, temperature measuring resistance, air release valve, gas leakage valve, and safety valve. 、Spray inlet joint.
2) Shelf: The energy required to cool and heat the materials is transferred to the shelves through the heat exchange medium to the materials. The shelf uses special hollow plywood, which has high strength and good sealing. The shelf assembly is installed in the freeze-drying cabinet through a bracket. The uppermost layer should be set up as a heat radiation compensation board to ensure that the material space in the cabinet is under the same temperature environment. In addition, both sides and the back of the shelf are Set up stop rails to prevent the material tray or material from getting off the shelf.
3) Box door: adopt cylinder automatic locking device. Ensure: the vacuum required during the internal pressure of the cabinet. When the vacuum pump is working, the front box butterfly room is opened. The air and water vapor in the vacuum drying room pass through the water trap to capture the moisture and enter the vacuum pump. The vacuum pump exhaust port is discharged from the system. The vacuum pump exhaust port is equipped with an oil mist trap. To prevent the smoke in the exhaust gas from polluting the indoor environment. In order to prevent water vapor from entering the pump, the system is equipped with a gas ballast valve, which is opened during the drying process.


